CPE & Access Gateway Products MP-202 Manual do Utilizador descarregar pdf (Página 10)

MP-20x Series

Debugging and Diagnostic Tools 10 Document #: LTRT-58201

4 SIP Logs

The MP-20x enables you to capture VoIP-related debug messages (including SIP stack,

call control, and VoIP application). The SIP logs are sent to the host through the network

port and can be captured using the Ethereal, Wireshark, or Syslog server tools. The

configuration is performed using Telnet.

¾ To activate the SIP logs:

1. Open a Telnet session with the MP-20x.

2. At the prompt, run the following commands:

rg_conf_set /voip/syslog/syslog_udp_terminal_flag [0-3]

rg_conf_set /system/rv_log_filter [0-7]

reconf 1

3. The default Syslog IP address is 192.168.2.2. The default port is 514. If you want to

change the default Syslog address and port, run the following commands (before

performing the reconf command):

rg_conf_set /voip/syslog/syslog_server_addr [Host IP

address]

rg_conf_set /voip/syslog/syslog_server_port [Host Port

address]

4. Activate Ethereal capture or Syslog server to capture the SIP logs.

5. Reboot the MP-20x.

Below are explanations regarding configuration options:

 /voip/syslog/syslog_udp_terminal_flag: defines the destination of the debug

messages:

• 0: Logs are not sent at all (default)

• 1: Logs are sent to the Syslog server

• 2: Logs are sent to the RS-232 terminal

• 3: Logs are sent to both the RS-232 terminal and Syslog server

 /voip/syslog/syslog_server_addr: default server address is 192.168.2.2.

 /voip/syslog/syslog_server_port: default server port is 514.

 /system/rv_log_filter: controls the modules for printing.

• 0: None

• 1: MTF + USR (note that MTF already includes USR)

• 2: SIP

• 3: MTF, USR, and SIP

• 4: USR

• 5: MTF and USR == 1

• 6: SIP and USR

• 7: MTF, USR, and SIP == 3

1 2 ... 5 6 7 8 9 10 11 12

Sem comentários

CPE & Access Gateway Products MP-202 Manual do Utilizador Página 10